☑ E12 Series Resistors Table

A higher number correlates to a lower tolerance and a higher precision. The e6 and e12 resistors are available in virtually all types of resistor.

Reading Part Values

Rlc부품 Standard Resistor Values Color Coding

Stock Forms Of Components

In the e12 series each succeeding resistor falls within the 10 of the previous value.

E12 series resistors table. Following this logic the preferred values for 10 tolerance resistors between 100 and 1000 ohms would be 100 120 150 180 220 270 330 and so on rounded appropriately. The resistance of resistors often follows the e series. This is the e12 series shown in the table below.

The 120 ohm resistor has a value ranging between 110 and 130 ohms. The e12 series is probably the most common series and exist for almost every resistor. The eia e series specify the preferred values for various tolerances.

E24 series tolerance 5 and 1. Values for resistors in these series are given below. All standard resistor values can be found in the table below.

Following this logic the preferred values for 10 tolerance resistors between 100 and 1000 ohms would be 100 120 150 180 220 270 330 and so on rounded appropriately. E6 e12 e24 e96. It consists of the e3 e6 e12 e24 e48 e96 and e192 series where the number after the e designates the quantity of value steps in each.

The e series consists of the e3 e6 e12 e24 e48 e96 and e192 series. Technical articles standard values used in capacitors inductors and resistors. However the e24 series being a much closer tolerance series is only available in the higher tolerance types.

Until fairly recently 10 tolerance resistors were the norm but today 5 e24 resistors seem to be the most commonly used. 28372 for technical questions contact. The e12 series of resistor values including their color codes.

The e series is a system of preferred numbers also called preferred values derived for use in electronic components. Standard values used in capacitors inductors and resistors. They still can be found in vintage radios old amplifiers etc but the price of a 5 resistor is low enough to be the standard component in all of todays electronic circuits.

Following this logic the preferred values for 10 tolerance resistors between 100 and 1000 ohms would be 100 120 150 180 220 270 330 and so on rounded appropriately. 22 aug 12 1 document number. The eia e series specify the preferred values for various tolerances.

Further series e48 and e96 are available but are not as common as the ones given below. This is the e12 series shown in the table below. The tolerance is 10.

This is the e12 series shown in the table below.